How To Clean Thermal Paste Off CPU Pins - Beware Before Making a Decision

How To Clean Thermal Paste Off Computer Parts

How To Clean Thermal Paste Off CPU Pins

If you are wondering how to clean thermal paste off computer cases, you may not want to mess with it. This can be one of the most difficult processes when you are dealing with an extremely dependable piece of equipment. Here is a step by step guide to get it done in no time at all.

 

The first thing that you will need to do is to remove any excess paste that is on the case. This can be done simply by opening up the case and removing all the hardware. Once this is done, you may then need to take some time to strip the heat paste. You can take a razor or any other kind of multi-purpose tool and slowly shave off the paste until it becomes a powder.

 

This is the key to properly removing heat paste from your system. Next, you will want to add a small amount of anti-static batteries into the case. Anti-static is used to reduce the amount of electricity that is in the case so you can reduce the amount of heat that is being moved to the CPU. Be careful when adding these though because you don't want to overdo it. Overloading the batteries may cause damage to your system.

 

Once you have added these items, it is time to remove the heat paste. To remove the heat, you will need to open up the vents in the back of the case. You can use a heat gun or a heat sprayer. Be careful with these tools though as they may damage the electronics if they are not used properly.

 

If you want to speed up the process, you can take a hair dryer to the job. You should only use a hair dryer for heat paste removal if you have not damaged the paste. Take all of the dried heat paste pieces and put them into a container. Zip close the container and place it in the freezer for about five minutes. This will speed up the drying process.

 

When this is done, it is time to remove the USB flash drive that contains the heat paste. You will need to take the device out of the computer. If the screws on the hard drive are facing away from the rest of the computer, you will have no problem removing it. Unscrew the device and remove the heat paste.

 

After this is done, you should carefully remove the paste with a heat gun or heat spray. This should be done to prevent any damage to the other parts on the motherboard or processor. Once the paste has been removed, look for any remaining heat sinks or heat shields.

 

Once you have done all of the steps needed to clean the heat sink or heat shield, reassemble your computer. If you notice that there is still some paste residue on your CPU, it is best to clean this area with the vacuum cleaner or a microfiber attachment to the vacuum cleaner. You should also clean the back plate of your heat sink if you have one. You should then complete the steps mentioned on the original instruction manual. If you are unable to complete these steps, you can ask for assistance from your computer expert or technician.

 

If you have removed the heat paste completely, you may use an area of your room that has direct heat to install your new heat sink or heat shield. This should not take long to complete as long as you use an adhesive pad to spread the paste onto the heat sink or heat shield. Once you are happy with the finished product, use your water based heat sealer once again to protect the new area. The area should be completely sealed for you to be able to use your computer again. Before using your computer, you should make sure that it is off and that nothing is in the way of the flow of air.

 

If you have a very old PC, you may find that certain parts require a bit more effort when cleaning. If you find that the instructions do not mention specific cleaning methods for your machine, you may want to contact your personal tech support for additional information. There are also some special products that can be used for how to clean thermal paste off computer parts. These products may be recommended by your manufacturer or tech support.

 

As you can see, there are several ways to remove a thermal paste. However, the best way is probably to use a heat sink or heat shield to remove the paste and allow it to air dry. If you are using your computer often, this should be your only option. If you use a heat paste, you should at least try to clean it to ensure that it does not attract or stick to anything else.